Bei der Suche nach Rollprüfständen sind mir die doch zum Teil recht hohen Preise ins Auge gefallen!
Aus diesem Grund habe ich beschlossen mir einige Rollböcke als Rollprüfstand selber zu bauen zu einem Bruchteil der Kosten die sonst entstehen würden.
Hier meine Materialliste:
Alu L-Profil 30 x 20 mm zugeschnitten in Längen von ~ 49mm
4 x geschlossene / gekapselte Kugellager 608 ZZ (8/22/8mm-Innen-/Außendurchmesser/Breite)
4 x Linsenkopfschrauben M8 x 16mm
4 x Unterlegscheiben
4 x Sechskantmuttern M8
1 x Acrylplatte ~ 61 x 49mm
4 x Linsenkopfschrauben M2 x 8mm und
4 x Sechskantmuttern M2
Zwischen den Kugellagern musste ich noch nachträglich eine Vertiefung machen damit eventuell Gestänge von Dampflokomotiven nicht auf das Alu stoßen.
While searching for test rollers for my running gear, I was taken aback by the rather high prices!
So I decided to built some myself at the fraction of the cost
My list of materials:
Aluminum L-profile 30 x 20 mm cut into lengths of about 49mm
4 x closed / sealed ball bearings type 608 ZZ (8/22/8mm - inner diameter/outer diameter/width)
4 x pan head screws M8 x 16mm
4 x washers
4 x hexagon nuts M8
1 x acrylic plate about 61 x 49mm
4 x Pan Head Screw M2 x 8mm
4 x Hex Nuts M2
A cutout has to be made between the rollers on each side so that any linkeage of the drive train does not interfere with the aluminum L-profile.
The member Stefan's Gartenbahn
confirms that he/she hold the rights to this picture
or is authorized to publish this picture.
The operator of the GartenBahn DataBase assumes no responsibility
for this picture and does not claim any ownership.
If you wish to exercise any legal claims, please contact the member directly Stefan's Gartenbahn.
All the information in this Gartenbahn Database is provided voluntarily by registered members.
We are unable to verify all of this information and can therefore not
accept any liability should any of the his information be incorrect.